You still need to make an effort.
Bosch washing machine door lock problem.
A problem with the door both opening and closing properly can be caused by clothes especially smaller garments such as socks becoming jammed between the door and the washing machine housing.
Bosch stuck washing machine door.
Remove the detergent drawer.
Install it in place.
Depending on the model of your bosch washing machine there are several ways that the child lock can be deactivated.
To determine if the door lock has failed electrically use a multimeter to test each of the door lock switches for continuity.
When the child lock is activated there will either be a key symbol or a cl symbol in the display and all the washing machine buttons will be disabled.
Bosch washing machine door stuck and how to open it.
Bosch washing machine fault codes are designed to show when the appliance has detected a problem.
The door latch secures the washer door shut during operation.
A selection of error codes is shown here but may differ depending on your model.
Ensure that there are no clothes caught between the door and the housing before starting a programme.
2 the ntc heater or bi metal strip fail 3 the plastic gets to hot and distorts inside the lock causing it to jam.
Note you must not run the washer without the filter.
Inspect the door lock for damage.
Washing machine door locks really only get 3 major faults 1 the points between live and common fail in some way.
You may need a manual for your bosch washing machine.
Door lock can fail either mechanically or electrically.
If the washer door is not latched shut the door switch will prevent the washer from operating.
If the door lock is damaged or does not latch properly replace it.
The washing machine drum is overloaded.
If the door lock is defective the washer door will not latch properly.
Once the washer door is closed the washer can begin operating.
The door latch can fail either mechanically or electrically.
Unscrew the bolt in the bottom right corner.
In fact it is not difficult.
Once the washer door is closed the washer can begin operating.
To clean or replace the drain pump pump you need to remove the front panel properly.
These codes may be digitally displayed as follows.
